Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to stop a process from my application's main figure?

  • Thread starter Thread starter -
  • Start date Start date
Status
Not open for further replies.

Guest
Hi anyone,

My program execute a certain process. I need to be
abble to cancel it at any moment by pressing a button without going out my application.
It would be a kind of CONTROL+C but it would occur while the application's main figure is opened, i.e., without going out the application.

Thanks in advance,

CRIS
 
Hi,
The simplest way to do it is to put at your application a check for the button state:
if get(h,'value')==1
pause
end
The value of the button handle h should be defined (either it is created during the application start or transferred as input or as global). Put those lines in the main loop or at several points along the way.

Joe
BSTEX - Equation viewer for Matlab
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top