Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to model an electrical transmission line

Status
Not open for further replies.

martinxtm

Mechanical
Joined
Nov 23, 2011
Messages
1
Location
CA
Hey,
I want to model an electrical transmission line to do time/frequency domain reflectometry measurements with it. Therefore I need something like a port to send voltage pulses in my model.
My model is a two-wire transmission line and I have problems to set up the right port for it.

I want to export the solution to a touchstone file and figured that it is possible via spswp command. Then plot it with pltd command. The problem is that it fails to write the touchstone file because I can't manage to set up the right port/port options. I tried now all different models with all different ports, the only one that worked was a coax cable.

Has anyone done anything like that before?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top