HosseinAgha
Mechanical
Hi,I want to have axial load in a modal analysis but I can't do that because the Force option is gray.
Thanks in advance for any help
Thanks in advance for any help
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to have an axial load in modal analysis
- Thread starter HosseinAgha
- Start date
- Status
FEAdesserve
Mechanical
Do a static analysis using an axial load first. Then use the pre stress analysis to calculate modal analysis results.
If you use workbench, then add a structural environment using axial load. On the solution tab, right click and then choose "transfer data to new modal analysis" then conduct the modal run.
Raj
If you use workbench, then add a structural environment using axial load. On the solution tab, right click and then choose "transfer data to new modal analysis" then conduct the modal run.
Raj
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question