dbernard2012
Petroleum
Forum, 200 butt welds ranging in sizes from 3/4 inch to 12 inch pipes, how can one attempt to figure how much electrodes are needed? will appreciate the input please.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
how to figure out how much electrodes is needed for the job
- Thread starter dbernard2012
- Start date
- Status
- Chapter 5
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
PersonalProfile
Mechanical
Apologies that I cannot be more specific [as I do not have access to my copies], however: one, or more; of the following Lincoln books provide guidance.
Some consumables' suppliers also provide guidance.
Some consumables' suppliers also provide guidance.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Question
- Question