Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to display nodal diameter in postprocessor?

Status
Not open for further replies.
Lirock

Lirock

Mechanical
Joined
May 27, 2006
Messages
75
Location
CN
Hi,everyone:
I did a modal cyclic symmetry analysis.But in the post1,I can't display nodal diameter.There are just hrm index.
If anyone can tell me how to display nodal diameter in POST1?
 
Status
Not open for further replies.

Similar threads

d0
  • Locked
  • Question Question
Nodal Forces
Replies
1
Views
796
NRP99
NRP99
H
  • Locked
  • Question Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
3K
karachun
karachun
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
M
  • Locked
  • Question Question
ANSYS Mechanical Scripting: how to delete an existing heatflux?
Replies
0
Views
829
MihailW
M
IJR
  • Locked
  • Question Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
1K
IJR
IJR

Part and Inventory Search

Sponsor

Back
Top