Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to display nodal diameter in postprocessor?

Status
Not open for further replies.

Lirock

Mechanical
Joined
May 27, 2006
Messages
75
Location
CN
Hi,everyone:
I did a modal cyclic symmetry analysis.But in the post1,I can't display nodal diameter.There are just hrm index.
If anyone can tell me how to display nodal diameter in POST1?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top