how to create a hole chart

[DDJCAD]

Ihave metric thd. size which is not available in the std. iso holetoolbar menu


how do I add this? step by step help will be useful(help menu says create a ??.hol file)how and where?


wf3 m090 standalone
Edited by: DDJCAD

 

[Linus Johansson]

Check out C:\Program\proeWildfire 3.0\text\hole (or wherever you have it installed)


Open up one of the files in any texteditor, then you should be able to figure out how it works.


It's a bit hard to explain in text what every parameter in these textfiles stands for.


You can add information in an excisting file or you can create a new file. This is not too hard once you figure it out.


Good luck!

 

[jabbadeus]

Note that it's recommended that you don't edit the tables located in the <loadpoint>\text\hole folder, but you copy them to some other location and edit as necessary.


Use the config option hole_parameter_file_path to point to the location of your custom hole tables.