Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to constrain a rotating cylinder

  • Thread starter Thread starter avichals
  • Start date Start date
A

avichals

Guest
How do I constrain a rotating cylinder for structural analysis?
 
I also would like to know this.
 
Is a cylindric coordinate system a useful solution for you?


Additionally in creo, i think there is a possibility to use cylindric constraints.


Can u share your experiences , i also whould know about this problem?!
 
You must log in or register to reply here.

Similar threads

BryanAyers
  • Locked
  • Question Question
Creo 9 drawing's tables, "part perimeter", how to setup?
Replies
0
Views
858
BryanAyers
BryanAyers
jasongBSME
  • Locked
  • Question Question
Converting from Pro/Mechanica to Creo Simulate
Replies
0
Views
807
jasongBSME
jasongBSME
DKrol
  • Locked
  • Question Question
Export STEP file from Creo to Solidworks
Replies
1
Views
818
goeasyon
goeasyon
W
Flow Simulation : air around an rotating cylinder
Replies
0
Views
4K
Wyrold
W
W
Flow Simulation : air around an rotating cylinder
Replies
0
Views
3K
Wyrold
W

Part and Inventory Search

Sponsor

Back
Top