andradesilva
Materials
Hi all!
I am trying to mesh a shell in the Polyflow module in ANSYS Workbench 18.1. I am used mapped meshing with 5 Divisions. The problem is that I want to adjust the number of lines with nodes on the radial direction and if I change the number of divisions I only change the number of divisions on the longitudinal direction, which I don't want. I want to adjust the number of lines on the radial direction. I currently have 23, no matter how many divisions I choose. I am sending screenshots with 5 divisions and 11 divisions, just to make it easier to understand. I also attach the mapped mesh parameters, just in case that something is wrong there.
Thanks in Advance,
Best wishes,
Andrade Silva
I am trying to mesh a shell in the Polyflow module in ANSYS Workbench 18.1. I am used mapped meshing with 5 Divisions. The problem is that I want to adjust the number of lines with nodes on the radial direction and if I change the number of divisions I only change the number of divisions on the longitudinal direction, which I don't want. I want to adjust the number of lines on the radial direction. I currently have 23, no matter how many divisions I choose. I am sending screenshots with 5 divisions and 11 divisions, just to make it easier to understand. I also attach the mapped mesh parameters, just in case that something is wrong there.
Thanks in Advance,
Best wishes,
Andrade Silva