how to change LC 3015BIIINT language settings

[nghia tran]

Dear,
Please support me how to change from japanese language to English for Laser LC 3015 BIII NT. it is using AMNC-PC .
Thanks
Nghia

 

[ausman]

If it's the newer control it's just a parameter.
If it's the older AMNC control (just the touch screen panel) it needs a firmware update (very difficult)
If you already bought it then you might need to learn Japanese, it's probably easier than getting the firmware files.

 

[nghia tran]

Thank you very much. Do you know scale percent between n2,o2,he into mixture gas?
Nghia

 

[Km3l3on]

hi, i have a LCG 3015 CO2 laser with a AF3500i-C resonator. The gas mixture is 5% CO2; 60% He; and 35% N2; but if you want to know the gas type used for cutting, then 1,2,3 are for oxigen cut, 4 is for nitrogen cut and 5 is for air shop cut

 

[jjl1210]

7 is use for high pressure nitrogen where you adjust the pressure with a dial usually for anything over 7kg.

 

[nghia tran]

Dear all,
Please guide me install amnc laser on amnc pc of laser lc 3015 biiint.
Thanks
Nghia