Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to avoid face/intracell buckling(honeycomb impressions) of GFRP panel with 1.5mm thick face sheet

Status
Not open for further replies.
G

Guru9

Industrial
Joined
Nov 20, 2024
Messages
1
Honeycomb impressions are quite visible on GFRP panel during production. Face sheet thickness is 1.5mm
 
Status
Not open for further replies.

Similar threads

MAEngr
  • Question Question
How to attach concrete buttress wall to toe side face of CMU retaining wall?
Replies
7
Views
4K
MAEngr
MAEngr
Struct2468
  • Locked
  • Question Question
For a 3 sided structure with an open face, would you apply both windward and leeward wind pressures to wall opposite of the open face?
Replies
5
Views
2K
JoshPlumSE
JoshPlumSE
cramsey
  • Question Question
Honeycomb Wall Repair
Replies
1
Views
7K
jhnblgr
jhnblgr
S
  • Question Question
Buckling analysis with contact using ABAQUS
Replies
0
Views
1K
sajjad_ef
S
PSUengineer1
  • Locked
  • Question Question
Vertical Streaks on CMU inside face
Replies
4
Views
1K
milkshakelake
milkshakelake

Part and Inventory Search

Sponsor

Back
Top