4mranch1
Aerospace
- Jun 27, 2007
- 87
I have run into this situation before (Using SW2007) and have yet to figure out the best/easiest method to do this. I have a round boss created with revolve and now would like to add a threaded hole in the center of that boss. System will not allow choosing the center point using the revolve sketch. Can someone help me please?
Gary Ashby
Designer
UG/NX V8 Thru NX5
SolidWorks 2007
AutoCAD 2002 & 2008
Gary Ashby
Designer
UG/NX V8 Thru NX5
SolidWorks 2007
AutoCAD 2002 & 2008