Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How do you change the orientation of an object?

Status
Not open for further replies.
Geno678

Geno678

Aerospace
Jun 23, 2010
53
How can I put this in better words, how do you change the reference planes so that you can make a new place to be your axis. I have two objects in my assembly, and they don't line up because the other object is slightly rotated at another angle.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Use the assemblie constraints.
Best regards.

MERMET Sebastien
Mecanical & Product Designer
SolidEdge ST2 & Unigraphics NX4 & 6
Dell precision 490 & Dell precision M6300
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

J
  • Locked
  • Question
VBA to Pull Total Surface Area and Volume for a Part of an Assembly?
Replies
0
Views
1K
jdconnel
J
jcpalekar
  • Locked
  • Question
How to handle occurrence properties of solid edge through excel sheet?
Replies
0
Views
926
jcpalekar
jcpalekar
NirVidP
  • Locked
  • Question
How to 'Create Part In Place' using vba?
Replies
0
Views
879
NirVidP
NirVidP
RC-o2
  • Locked
  • Question
The rollback event cannot allow saving of the active document because we could not get valid pointer
Replies
0
Views
767
RC-o2
RC-o2
Vikas4auto2019
  • Locked
  • Question
How to add bulk components in to the assembly.
Replies
0
Views
812
Vikas4auto2019
Vikas4auto2019

Part and Inventory Search

Sponsor

Back
Top Bottom