I am having a problem with the BoM I created to show on our drawings. It is only coming in as 44 rows long and then it is splitting it's self. Is there a way to change this so that it shows a certain number of rows and then splits? Or even comes in as one table with all the parts (I will need to know how to split it if this is the case)? I am using NX 8.5 with Teamcenter R31V5.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
How do I make my BOM table more than 21 rows. 1
- Thread starter Jraik22
- Start date
- Status
Similar threads
- Locked
- Question