holes partern problem

[2433]

Hi
Anyone out there can help me with this problem
I have a part with 45 deg. cut and I want to add 5 holes
vertical with part, the depth of the holes must be equal depth of the 45 deg. cut surface. but the bottom of the holes must be horizontal.

thank you

 

[SBaugh]

Why can't you just use a plane or a cut revolve? Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.3dmca.com

faq731-376
When in doubt, always check the help

 

[drawoh]

2433,

If you can define a plane at the depth of the 45 degree cut, you can place your sketch there, and do a through-all cut to the top surface.

Having defined this plane, you have the alternative of sketching and cutting down from the top surface, to your plane.

JHG