Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hole wizzard

Thread starter vlong
Start date Feb 27, 2004

Status: Not open for further replies.

Feb 27, 2004

vlong

Mechanical

I am wanting Hole Wizzard to have the ability to put the proper size hole in a sheetmetal part for PEM studs, standoffs and nuts. I also would like to be able to pick "standard" size obrounds. If the designer knows what size fastener they are using I would like it to be simple to pick an obround to use (similar to clearance holes). I am wanting/needing this so that we can create a company standard. Any help is appreciated.