I am wanting Hole Wizzard to have the ability to put the proper size hole in a sheetmetal part for PEM studs, standoffs and nuts. I also would like to be able to pick "standard" size obrounds. If the designer knows what size fastener they are using I would like it to be simple to pick an obround to use (similar to clearance holes). I am wanting/needing this so that we can create a company standard. Any help is appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hole wizzard
- Thread starter vlong
- Start date
Similar threads
- Question
- Locked
- Question