Hole Wizard Major/Minor Diameters 2

[Bester2]

Is it possible to have the hole wizard created the minor diameter geometry and not the major diameter geometry? Here is the issue; I send out parts that are used to cut the geometry along with drawings. If my supplier uses the models to make the parts he could theoretically cut too large of a hole if he does not catch the difference in the drawing. I know that the drawing states that it is a tapped hole but the model shows a hole that is too large (By the way this has not happened yet but I could see it happening in the future especially when I am pressed for time).

 

[CorBlimeyLimey]

There is an option within the HW manager for exactly that.

 

[brengine]

Cosmetic Thread. It's an option in the Hole Wizard feature dialog.

Ken

 

[Bester2]

CBL and KenBolen,

Thanks I appreciate the help. I would not of found that one out on my own.

Brian

Brian
SW 2006 SP 4.1