Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hole in a Solid 1
- Thread starter blackwed
- Start date
-
1
- #2
Hi,
You need todo the following steps:
set the UCS on the side you want to treat.
draw a (polyline)rectangle.
use the EXTRUDE command or button and select the object
enter a heigth and no taperangle.
use the SUBSTRACT command or button and select the main object and then the object you want to substract from it.
use hide to see the effect
Enjoy ;-)
You need todo the following steps:
set the UCS on the side you want to treat.
draw a (polyline)rectangle.
use the EXTRUDE command or button and select the object
enter a heigth and no taperangle.
use the SUBSTRACT command or button and select the main object and then the object you want to substract from it.
use hide to see the effect
Enjoy ;-)
- Status
Similar threads
- Locked
- Question