Hole dimension leader

[enuf4u]

Is there any way in wildfire 2.0 to dimension a hole (diameter not radius) and have one leader with one arrow? It currently displays two arrows 180° apart either pointing at the interior or exterior of the hole.

Thanks in advance

 

[3dlogix]

Double click or right-click the dimension and pick FLIP ARROWS.

http://www.sprdesign.com

http://www.3dlogix.com

 

[enuf4u]

When I FLIP ARROWS all it does is change the direction the arrows are pointing. The dimension leader still has two arrows; one on each side of the hole; Inside pointing out or outside pointing in. I basically want a leader (one arrow like the radial dimension shows, but I want a diameter dimension), but I want the dimension on the drawing to update when the hole in the model changes.

Thanks for the quick response

 

[3dlogix]

The double leader only happens when the actual dimension is located inside the circle. Just drag it away from the circle, then flip arrows as required.

http://www.sprdesign.com

http://www.3dlogix.com

 

[enuf4u]

I found what my problem was... In Drawing Options, set Text_Orientations to: parallel_diam_horiz; mine was set to parallel. After I done this, the flip arrow choices gave me my desired leader.


Thanks!

 

[3dlogix]

I had a look at that config setting, and yes, those are usually set for ISO spec drawings (parallel settings...). I should have read your question a bit more.

Glad it worked out.

http://www.sprdesign.com

http://www.3dlogix.com