Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hole callouts; editing? 1

Status
Not open for further replies.

Gigatt

Mechanical
Joined
Sep 23, 2004
Messages
12
Location
US
Is it possible to edit the number of pieces in hole callouts? I want to automatically put parenthesis around the value?
"2X 5/16-18 UNC-2B" becomes "(2X) 5/16-18 UNC-2b".
The command is <NUM_INST>. I thought I could put parenthesis around that command, but when I searched calloutformat.txt I cannot find it? Thanks in advance, GIGATT
 
The command is <NUM_INST>. I thought I could put parenthesis around that command, but when I searched calloutformat.txt I cannot find it?
 
Gigatt, try to stick with the ANSI standard which is number of items without parenthesis. In this case "2X 5/16-18 UNC-2B" is standard, "(2X)..." is not.
 
If you can't find it by searching. Then have you tried checking your file locations in Tools\Options\System options\File locations\Hole callout format file - ? If your inserting Hole callouts, then it has to be pulling the data from somewhere.

Regards,

Scott Baugh, CSWP [pc2]

faq731-376
 
Scott, thanks for your time. I have been in this file "\Solidworks\Lang\English\Calloutformat.txt", since the beginning. The question is where can I find that command "<NUM_INST>? It is not in that file. I guess I should go with netshop21's advice unless someone else can help me.

 
Ohhhh I see - Form your first post I thought you said you couldn't find the calloutformat.txt file. - Sorry for the mis understanding!

You should take either netshop's or DesignSmith from thread559-86931

Regards,

Scott Baugh, CSWP [pc2]

faq731-376
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top