Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hole Callout on Cross section

Thread starter Drhinehart
Start date Dec 7, 2005

Status: Not open for further replies.

Dec 7, 2005

Drhinehart

Mechanical

We are required to dimension our holes on a broken out cross section. Is there anyway to make SW05 create the same style call out that is created from the hole call out selection? Right now for tapped holes it places M8 for a tapped hole. Nothing to say if it's fine or course thread.

Thanks in advance,

Dale Rhinehart