Inventor is having trouble showing hole annotation symbols correctly for me. I created a custom hole annotation to show what inventor does when it tries to place an annotation symbol: Does anyone know how to fix this? Thank you.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
hole annotation problem
- Thread starter Nuson
- Start date
SeanDotson
Mechanical
Does it appear correctly for the standard hole notes? Trying to determine if this is a font or IV problem.
Sean Dotson, PE
Inventor Tutorials & More
Your Webbased mCAD Discussion
Sean Dotson, PE
Inventor Tutorials & More
Your Webbased mCAD Discussion
- Thread starter
- #3
SeanDotson
Mechanical
Ah that's probably it. The decimal, diameter etc.. symbols are represented by a font named AIGDT and AMGDT. Changing them to a font other than this will cause problems.
Make sure you even have these fonts on your system also. They sometimes get deleted when uninstalling software.
Sean Dotson, PE
Inventor Tutorials & More
Your Webbased mCAD Discussion
Make sure you even have these fonts on your system also. They sometimes get deleted when uninstalling software.
Sean Dotson, PE
Inventor Tutorials & More
Your Webbased mCAD Discussion
- Thread starter
- #5
Awsome. That worked perfectly. Thanks Sean. I deleted some fonts a while back because I had alot of similar and seemingly useless fonts. Obviously, I did not realize that I'd be needing those two... Scarey how you knew which ones they were 
. THanks!
. THanks!
SeanDotson
Mechanical
When you've used IV as long as I have you begin to hear all the problems.. 
Sean Dotson, PE
Inventor Tutorials & More
Your Webbased mCAD Discussion
Sean Dotson, PE
Inventor Tutorials & More
Your Webbased mCAD Discussion
- Status
