I am looking for a standard, guideline or specification that delineates the definition of HI-MODULUS versus LOW-MODULUS epoxies and polymers (tension and compression).
In other words, are there limitations for these properties, in terms of actual numbers, for a material to be defined as either a HI-MOD or a LOW-MOD polymer/epoxy?
As I browse through many tech data sheets for various manufacturers, the terminologies for modulus seem to be used over a wide variety of actual mechanical properties. This gives the impression it is really up to the manufacturer to define it.
In other words, are there limitations for these properties, in terms of actual numbers, for a material to be defined as either a HI-MOD or a LOW-MOD polymer/epoxy?
As I browse through many tech data sheets for various manufacturers, the terminologies for modulus seem to be used over a wide variety of actual mechanical properties. This gives the impression it is really up to the manufacturer to define it.
