Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hi friends Can I fill with wel
- Thread starter jim81276
- Start date
Where is the hole , in the baseplate, the engine block, crankshaft -- senseless question, we are not mind readers.
Plus this is the pump engineering forum, you should post in the appropriate forum.
It is a capital mistake to theorise before one has data. Insensibly one begins to twist facts to suit theories, instead of theories to suit facts. (Sherlock Holmes - A Scandal in Bohemia.)
Plus this is the pump engineering forum, you should post in the appropriate forum.
It is a capital mistake to theorise before one has data. Insensibly one begins to twist facts to suit theories, instead of theories to suit facts. (Sherlock Holmes - A Scandal in Bohemia.)
LittleInch
Petroleum
Maybe yes, maybe no.
How is anyone going to provide information based on one line??
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
How is anyone going to provide information based on one line??
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
- Status
Similar threads
- Question
- Locked
- Question