Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hi Engineers How to weld clean ou

Status
Not open for further replies.

MA69

Mechanical
Joined
Jan 5, 2022
Messages
4
Location
LY
Hi Engineers
How to weld clean out door base plate with annular plate? What is the welding procedure?
 
Whatever the materials and use case suggests...

Dan - Owner
Footwell%20Animation%20Tiny.gif
 
This is an API Storage Tank question ... Suggest that you post in "Storage tank engineering" forum

MJCronin
Sr. Process Engineer
 
I don't remember if there is any additional detail on that in API-650. But it may simplify things, at the cost of some material, to extend the base plate in as far as the annular plate.
 
I attached the photos of COD our API 650 Storage tank.
Tank Details:
Dia : 200 ft
Height : 48 ft
COD Base plate Thickness : 34mm
Annular plate Thickness ; 14 mm
As in our case, we are going to only replace the bottom reinforcement plate (or annular plate) of the clean out door.

Does we have to stress-relief the whole clean-out door assembly afterwards? or just PWHT of the new welding of the new annular plates to the new door reinforcement plate?

Or, in this case, is not required.

Please advise me.
 
 https://files.engineering.com/getfile.aspx?folder=5889c921-6230-4685-abcd-d776432128e2&file=Clean_out_door.png
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top