L
LmDogg
Guest
Hello!
I am fairly new to Solidworks and having problems with moving a predrawn part. It's a model of a Bosch Rexroth angle connector, namely this one:
Bosch Rexroth - look for part number 3842502688
The thing I'm struggling with is simply changing the angle between the two ends, which I would need as I'm building a model desk.
Any help is much appreciated.
Thank you,
Luka
I am fairly new to Solidworks and having problems with moving a predrawn part. It's a model of a Bosch Rexroth angle connector, namely this one:
Bosch Rexroth - look for part number 3842502688
The thing I'm struggling with is simply changing the angle between the two ends, which I would need as I'm building a model desk.
Any help is much appreciated.
Thank you,
Luka
