Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hebrew Font Notes in NX7.5

Status
Not open for further replies.
aeroseat

aeroseat

Mechanical
Joined
Aug 15, 2012
Messages
1
Location
US
I'm having some trouble getting a Hebrew note to display correctly. I've added Hebrew_Multimode.fnx from another post to my ugfonts directory and chosen it as the style (also tried Arial, etc). I'm using NX 7.5.5.4. Hebrew shows fine in the Edit Text box, but only shows as squares (and a comma) in the part. English text is working fine. Basically, I copy the Hebrew translations from my customer and need to paste it on my placard. Insert>curve>text works but then it's difficult to make changes. Any suggestions that would allow later editing?
Thanks,
Aeroseat
 
Status
Not open for further replies.

Similar threads

cadrebel
  • Locked
  • Question Question
docking part navigator NX7.5
Replies
4
Views
503
Rob_N
Rob_N
cadrebel
  • Locked
  • Question Question
selection preferences NX7.5
Replies
3
Views
340
cadrebel
cadrebel
NaomiG
  • Locked
  • Question Question
NX Drafting - Notes not showing on sheet
Replies
2
Views
765
NaomiG
NaomiG
rob768
  • Question Question
converting units in Femap
Replies
0
Views
6K
rob768
rob768
Manee123
  • Locked
  • Question Question
Export all notes to the spreadsheet in NX9 Drafting
Replies
3
Views
370
Manee123
Manee123

Part and Inventory Search

Sponsor

Back
Top