Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Heat Treating Alloy Plate

Status
Not open for further replies.
Billr2

Billr2

Materials
Joined
Oct 4, 2003
Messages
1
Location
US
What tips to consider that can help keep alloy plate (80" diameter x 5/8" thick) AISI 3150 flat when quenching from austenizing temperature into air between water cooled platens?

 
Status
Not open for further replies.

Similar threads

S
  • Question Question
Heat Treatment Simulators
Replies
1
Views
276
EdStainless
EdStainless
N
  • Question Question
Overly of ERCuAl-A2 over low alloy steel
Replies
6
Views
787
weldstan
weldstan
R
  • Locked
  • Question Question
Wet clutch plate material
Replies
0
Views
695
RickyW
R
S Jana
  • Locked
  • Question Question
For P275 NL2 material with a plate thickness greater than 40 mm, Post Weld Heat Treatment (PWHT) requirements
Replies
0
Views
1K
S Jana
S Jana
jetpackjbd
  • Question Question
Help finding a heat resistant, non-conductive, and pressure tolerant material
Replies
16
Views
10K
HTURKAK
HTURKAK

Part and Inventory Search

Sponsor

Back
Top