Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Head losses in reducers and diffusers

Status
Not open for further replies.
deasdi

deasdi

Mechanical
Joined
Aug 17, 2004
Messages
2
Location
US
Kindly help me by providing sources to find the equivalent lenths or head losses for reducers and diffusers. I need this for pipe sizes 6", 8", 10", 12" and above..

Thanks in advance!!
 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

H
  • Question Question
Maximum friction losses are 5% in pipes. Who said it first?
Replies
9
Views
3K
bimr
bimr
Briland33
  • Locked
  • Question Question
Piping Losses in an air Vacuum System
Replies
17
Views
1K
georgeverghese
georgeverghese
Drilling Integrity Super.
  • Locked
Differences in Minimum Allowable Stresses in ASME B31.3 for Low and High Pressure
Replies
3
Views
3K
GD2
GD2
1
  • Question Question
Dismantling Joint and Magnetic Flowmeter Installation
Replies
3
Views
9K
bimr
bimr
Lawry1183
  • Question Question
Requirement of Manual Ball valve between ESDV and MOV in Pig trap area
Replies
13
Views
5K
georgeverghese
georgeverghese

Part and Inventory Search

Sponsor

Back
Top