SurajTinani
Materials
As per ISO 15156-3 table A.2, hardness for Austenitic SS described in A.2 is 22 HRC. Is the value for the parent metal or the same hardness limit applies to HAZ and Weld as well? Thanks in advance!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hardness of SS316 parent metal, HAZ and Weld 2
- Thread starter SurajTinani
- Start date
- Status
EdStainless
Materials
As I understand it this is the max hardness for any and all locations.
And I would be scared of any values even close to it.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, Plymouth Tube
And I would be scared of any values even close to it.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, Plymouth Tube
-
2
- #3
See paragraph 1 of 6.2.2.2.4.
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question
- Locked
- Question