Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Gusset Plate Design for Column

Status
Not open for further replies.

1437n6

Civil/Environmental
Joined
Aug 5, 2007
Messages
25
Location
US
I have a short 8"x12"x1/2" TS column that is 5' tall, with one beam tying into it. Originally it was designed to support rolls of material basically resting on the top, with minimal lateral forces. However, there is now a need to push the load sideways on this column,introducing a signifcant lateral load. Is there a good document out to help with design of gusset plates to resist this?
 
1437n6:
The bigger questions might be, is the foundation able to take this moment due to the lateral loading, at the column base? Are the anchor bolts and base plate adequate? Do you need gussets to reinforce the col. base or a whole new base. What was a vertically loaded column is now a cantilevered beam/column, is it adequate. Maybe you need 45° diag. braces from 3' up on the col. down to the floor.

The AISC, ACI and AWS codes; a structural steel design and conc. design textbook and a mechanics of materials textbook would all be good references for helping solve your problem. A structural engineer might be helpful too.
 
I'm confused by; "push the load sideways on this column", does this mean perpendicular to the beam? How is the other end of the beam supported/restrained?

Michael.
Timing has a lot to do with the outcome of a rain dance.
 
Check the HSS without a gusset plate. It probably works. Then check the anchorage to see if it works.

BA
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top