Graphics Design in Pro Engineer

[carve34]

I have a company logo in a .tif format that I would like to put onto several of the models I am building. These will not be extruded or cut but more like a digital sticker. Any ideas on how to do this? I am working in Pro/E Wildfire 2.0

 

[design-engine]

trace sketch

Using ISDX a modual of Pro/E wildfire you can trace the sketch creating 3d geometry. Another solution would be to use a tool like Illustrator to generate line art that can be imported into Pro/E via IGES or DXF. Then you extrude the logo or font as needed.