Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Grain orientation at the hardening steel sheet

Status
Not open for further replies.
barboric

barboric

Materials
Jan 30, 2020
2
Grain orientation at the hardening steel sheet

Maybe you know which is best grain orientation in hardening(quenching) so that the pieces will deform as little as possible? Transverse or rolling direction?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Dear barboric,

It is the rolling direction.

Regards.

DHURJATI SEN
Kolkata, India

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

MechyMarco
  • Locked
  • Question
4340 Grain Structure of Plate Versus Round Bar After Hardening
2
Replies
20
Views
1K
EdStainless
EdStainless
Carl84
  • Locked
  • Question
grain direction detection in aluminium tubing 4
Replies
11
Views
638
Compositepro
Compositepro
Henry0726
  • Locked
  • Question
Steel - Hardening behavior after cycles - Stress/strain Curve
Replies
5
Views
775
IngeniousQuest
IngeniousQuest
KristjanGerhard
  • Question
Unknown steel
Replies
9
Views
5K
mrfailure
mrfailure
efulm4444
  • Question
Strength of C36000 Brass at Elevated Temperatures 1
Replies
1
Views
269
MintJulep
M

Part and Inventory Search

Sponsor

Back
Top Bottom