Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Governing Thickness Preheat ASME B31.3 1

Status
Not open for further replies.
Jeldon

Jeldon

Chemical
Joined
May 20, 2013
Messages
25
Location
BR
How do I know what the nominal thickness to be used for preheating of joints type branch connection. Type FIG. 328.5.4D - Sketches(1) (3) and (5).
Thanks to everyone.
 
Sort by date Sort by votes
Read Requirements in 330.1.1. "the thickness intended is that of the thicker component measured at the joint".
In sketches 3 & 5 you have to check three welds individually.
 
Upvote 0 Downvote
Dear Camba, thank you for the reply. Then the thickness is considered to be the largest in the joint. Hugs from Brazil
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jayinwww
  • Question Question
Calculating Stress Ratio ASME B31.3 Figure 323.2.2A Note 6
Replies
0
Views
483
jayinwww
jayinwww
Drilling Integrity Super.
  • Locked
Formula for Calculating Basic Allowable Stresses in ASME B31.3
Replies
2
Views
5K
Geoff13
Geoff13
T
  • Question Question
Figure 323.2.2-2 (Reduction in Lowest Exemption Temperature for Steels Without Impact Testing) of ASME B31.3
Replies
0
Views
7K
Tommy2025
T
Karik87
  • Question Question
Combine thickness and diameter qualified range of welder according to ASME IX
Replies
4
Views
1K
Karik87
Karik87
LeoSter
  • Locked
  • Question Question
ASME B16.9 wall thickness tolerance
Replies
2
Views
1K
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top