Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Geopak Surfacing

Status
Not open for further replies.

namdac

Civil/Environmental
Dec 30, 2002
205
US
I have been trying to interpolate between sections. When I do I get an error message "color mismatch" and when the surface comes in I have a warped and twisted surface. Any Ideas?
Also, I would like to add intersections. I have tried to copy the design into the 3-D file. Should I run a profile along the edges I want to layout in the 3-D file?
 
Replies continue below

Recommended for you

It looks like you may have some elements that are the wrong color. Geopak uses level and symbology to distinguish between different element types (road surface, etc.)

My recommendation is to use the Edit>Select By Attributes function to find the rogue elements.

Good luck,

Robert Weber, EI
Maurer-Stutz, Inc
"I am satisfied that your answer is correct. I am not, however, satisfied that your answer is right."
 
RAWeber,
Thanks for the tip. It seems to work. I will try that along with trying the power selector. That should do it.
Regards,
NamdacB-)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top