SteveFarnsworth
Mechanical
I'm using GEOPAK 2000 Series software on a Mitutoyo CMM. In the alignment process I get Error Code 63002 after getting one or two hits of the probe...any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mitutoyo CMM GEOPAK 2000 Series Error Code 63002
- Thread starter SteveFarnsworth
- Start date
- Status