jadham2
Automotive
- Dec 8, 2014
- 1
Hello guys,
I have question regarding addition of Geometric tolerances to control rectangular form of 2.3mm thick pad of IN70 material.
do we required it on drawing ?
if yes how they will measure this for this thick material ?
if no, how they will make sure that its rectangular & not parallelogram ?
Thank you.
I have question regarding addition of Geometric tolerances to control rectangular form of 2.3mm thick pad of IN70 material.
do we required it on drawing ?
if yes how they will measure this for this thick material ?
if no, how they will make sure that its rectangular & not parallelogram ?
Thank you.