A
ajv
Guest
Hello all,
I have a question about adding geomatric tolerances in Solidworks 2011. I'm trying to get a symmetric tollerance with two arrows which are pointing at each other. (example image below)
But I can't find a propper way to get this done. In Solidworks I can only find how to get several arrows with the starting point, but not how to point out this for the tolerance.
Thanks in advance!
AJ
(I hope I explained it clearly, since English is not my first language)
I have a question about adding geomatric tolerances in Solidworks 2011. I'm trying to get a symmetric tollerance with two arrows which are pointing at each other. (example image below)
But I can't find a propper way to get this done. In Solidworks I can only find how to get several arrows with the starting point, but not how to point out this for the tolerance.
Thanks in advance!
AJ
(I hope I explained it clearly, since English is not my first language)
