Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Generate line from a KP tangant to an Arc

Status
Not open for further replies.
nodalDOF

nodalDOF

Mechanical
Joined
Oct 3, 2005
Messages
100
Location
US
Is there a command in ANSYS to generate a line from a given key point that is tangent to an existing cicular arc (or say another line)?

Thanks,
Nodal DOF
 
Sort by date Sort by votes
Take a look at the commands LTAN and L2TAN.

Regards,
Alex
 
Upvote 0 Downvote
Thanks Alex. LTAN Works.

Nodal DOF
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

M
  • Locked
  • Question Question
ANSYS Mechanical Scripting: how to delete an existing heatflux?
Replies
0
Views
832
MihailW
M
AndrewSkocz
  • Locked
  • Question Question
Ansys - Solving an input file using command line
Replies
3
Views
1K
NRP99
NRP99
H
  • Locked
  • Question Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
3K
karachun
karachun
W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H

Part and Inventory Search

Sponsor

Back
Top