Jun 18, 2012 #1 hugou Automotive Joined Sep 17, 2008 Messages 39 Location GB How on earth do you set up datum planes for a part with no holes or mounting details and only one small flat surface and one straight edge (neiter of which are really significant features)? Any advice would be gratefully received.
How on earth do you set up datum planes for a part with no holes or mounting details and only one small flat surface and one straight edge (neiter of which are really significant features)? Any advice would be gratefully received.
Jun 18, 2012 #2 KENAT Mechanical Joined Jun 12, 2006 Messages 18,387 Location US I'd suggest looking into datum targets. You may be better off posting in forum1103. Strongly suggest that if you re-post there you state what standard you are working too. Also Red Flag this post for deletion. Posting guidelines faq731-376 http://eng-tips.com/market.cfm? (probably not aimed specifically at you) What is Engineering anyway: faq1088-1484 Upvote 0 Downvote
I'd suggest looking into datum targets. You may be better off posting in forum1103. Strongly suggest that if you re-post there you state what standard you are working too. Also Red Flag this post for deletion. Posting guidelines faq731-376 http://eng-tips.com/market.cfm? (probably not aimed specifically at you) What is Engineering anyway: faq1088-1484