aminjamali
Civil/Environmental
I try to model a simple Gasket problem but I can't mesh the Gasket region, I get an error. Does anyone have faced this error? Please see the picture attached.
Thanks a lot
Thanks a lot
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Gasket meshing problem
- Thread starter aminjamali
- Start date
- Status
Stringmaker
Mechanical
Be sure that TYPE is set to the correct element type for your gasket. Also, make certain that gasket elements are in fact 2D. Sorry, I don't have any experience with them.
- Thread starter
- #3
aminjamali
Civil/Environmental
The element type is set to be the correct one, it's 2D either. I don't know what might be the reason for this error. Anyway thanks a lot for the help.
Amin
Amin
- Thread starter
- #4
aminjamali
Civil/Environmental
I think I found the solution.The error was because I wasn't following the right meshing procedure. The help is very clear about this.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question