Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Forged Hollows and Blanks as per UG-14

Status
Not open for further replies.
f5iqg

f5iqg

Mechanical
Joined
Mar 14, 2012
Messages
2
Location
DE
Inquiry : May a forged hollow be used to made flange up to NPS 32", there is no objection with the requirement of the ASME UG 14.

See the comment from Notified body
As informed, it is observed the constructor had procured Forged Hollows and Blanks of different sizes and then machined further in their shop to make Weld Neck/ Slip On flanges which is not acceptable.
 
Sort by date Sort by votes
see code case 2156 and different thread in this forum.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mechengineer
  • Question Question
Studding Flange Design as per Code
Replies
1
Views
3K
r6155
r6155
GinBread
  • Solved
Interpretation of UG-32(i) ASME F&D Heads
Replies
4
Views
7K
GinBread
GinBread
FAHADRANA
  • Locked
  • Question Question
WQT for Combination of Welders as per ASME Sec IX
Replies
3
Views
4K
DekDee
DekDee
YuJie_PV
  • Locked
  • Question Question
Membrane or Membrane+Bending when assessing local failure protection per ASME VIII-2
Replies
8
Views
7K
YuJie_PV
YuJie_PV
mrpsi
  • Locked
  • Question Question
Qualifying A4-70 bolt per ASME B31.3
Replies
2
Views
989
mrpsi
mrpsi

Part and Inventory Search

Sponsor

Back
Top