Hi - I have a question on thread554-155134 which was posted in May. Is the correct thing to do to start a new thread? In other forums that I have used, most members did not appreciate old threads being resurrected, so that is why I am posting this as a follow-up question.
The thread is about modifying parts in an assembly and creating interesting patterns... the poster (Hora) states that the procedure is MODIFY->MOD ASSY->MOVE in ProE 2001. Another poster (3dlogix) later states that this is also possible in Wildfire. I use Wildfire but I haven't been able to figure out where this menu item is?
All I need is a nudge in the right direction - thanks
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
The thread is about modifying parts in an assembly and creating interesting patterns... the poster (Hora) states that the procedure is MODIFY->MOD ASSY->MOVE in ProE 2001. Another poster (3dlogix) later states that this is also possible in Wildfire. I use Wildfire but I haven't been able to figure out where this menu item is?
All I need is a nudge in the right direction - thanks
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.