Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flying optics
- Thread starter fab3
- Start date
I believe you need to contact the manufacturer of your machine about the alignment procedure if you are referring to the external optic alignment. Usually on a flying optic system the resonator must be leveled (if not mounted on the frame) or the machine needs to be leveled. The X-Axis alignment must be parallel (up and down/ side to side) which means you may have to do the crosshair or target burns at the near side (by the resonator) and the far side (end of the cutting table).
Again, contact your OEM or check your operation manuals.
Again, contact your OEM or check your operation manuals.
- Thread starter
- #4
- Status