So, I've been messing around with a hybrid water block-heat pipe design for a few months. I'm just crossing out possibilites for fun with a sla printer and a miniscule budget. Anyway, I want to experiment with adding more mixing to some prototypes, and I have no idea what a submersible motor looks like that would fit inside the space between the heat pipes and fins I want to use. Any ideas?
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
fluid mixing inside a water block
- Thread starter MisterE2
- Start date
LittleInch
Petroleum
Drawing? Sketch? Dimensions?
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
- Thread starter
- #3
- Status