A centrifugal pump operates at speeds of 200~400Hz, and a flow meter will be installed 10 meters away from this pump. The natural frequency of the flow meter was found to be around 200Hz from SolidWorks Cosmo. The fluid is a high pressure and high temperature water. So how much should the natural frequency of the flow meter be increased to avoid structural resonances?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flow Meter Vibration Problem
- Thread starter James08
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Question
- Locked
- Question