Trying to model a floating skimmer device and not sure what flow to input in HydroCAD. Per the skimmer manual I will need two 6 inch skimmers w/H=0.417. The Basin volume needed to drain in 72 hours is 226,357 cuft. I have phase in depth set at 0.42 ft and Full flow set at 1.03 cfs.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Floating Skimmer Device
- Thread starter ftroop82
- Start date
Use the orifice equation to calculate the flow, based on the head and the skimmer geometry.
Hydrology, Drainage Analysis, Flood Studies, and Complex Stormwater Litigation for Atlanta and the South East -
Hydrology, Drainage Analysis, Flood Studies, and Complex Stormwater Litigation for Atlanta and the South East -
I'm not sure what you're asking. If you've already determined the full flow to be 1.03 CFS, just enter that value into the constant-flow outlet device.
Peter Smart
HydroCAD Software
Peter Smart
HydroCAD Software
- Status
Similar threads
