Hi.
I have a problem with a flatt pattern view in some of my drawings. I noticed that a bend line has a bend definition UP 0° SHARP, and it should be UP 45° SHARP. I tried making the flatt pattern view again but it does the same thing. In a similar drawing ( of a practically identical part with a smaller hole at the top ) I have no such problems.
I have attached a drawing in pdf format for better understanding of the problem. Does anyone have any ideas?
Best regards,
Vid Golob
R&D
TRM Filter
Slovenia
I have a problem with a flatt pattern view in some of my drawings. I noticed that a bend line has a bend definition UP 0° SHARP, and it should be UP 45° SHARP. I tried making the flatt pattern view again but it does the same thing. In a similar drawing ( of a practically identical part with a smaller hole at the top ) I have no such problems.
I have attached a drawing in pdf format for better understanding of the problem. Does anyone have any ideas?
Best regards,
Vid Golob
R&D
TRM Filter
Slovenia