We've got a client who wants to connect a pressure relief discharge to the bottom of the flare header... I know that recommended practice is to connect to the top of a flare header to prevent condensables from traveling back toward the relief device. Is there some ASME, API, OSHA code that specifically states not to connect to the bottom of a flare header? Any help with this is appreciated!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flare header connections
- Thread starter MikalT
- Start date
Well, make sure the process guy sizing the PSV accounts for that full liquid column he'll have sitting on top of that discharge.
Or, you could just have them drill a weep hole at that first elbow, like on an open PSV to drain the liquid.
Yes, that last one was a joke! Edward L. Klein
Pipe Stress Engineer
Houston, Texas
All opinions expressed here are my own and not my company's.
Or, you could just have them drill a weep hole at that first elbow, like on an open PSV to drain the liquid.
Yes, that last one was a joke! Edward L. Klein
Pipe Stress Engineer
Houston, Texas
All opinions expressed here are my own and not my company's.
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
